INSTALLING ON WINDOWS VISTA

When you install our software on Windows Vista you must follow the

instructions below to get a product registration code that will unlock the

program. If you do not follow these steps the registration code we issue will

not unlock the program.

Step 1

Install the program from the CD according to the installation instructions

provided with the software. You will receive a message that the

program installation was completed successfully. When finished

do not open the program until you have completed the rest of these steps.

Step 2

Set the program to run in Windows XP compatibility mode as follows…

Go to Start, All Programs and click on the appropriate program group.

Locate the shortcut that opens the program, right click on it and choose properties.

In the Properties window click on the Compatibility Tab.

Place a check mark in the box next to “Run this program in compatibility

mode for: ”Windows XP (Service Pack 2)”

Also Place a check mark in the box next to “Run this program as an

administrator”.

Click on the “Apply” Button and then click on the “OK” button to close the

properties window.

Step 3

Then open the program. When you come to the registration screen where you

see the System ID (that we need to use to calculate your registration code ),

Write down the system ID then cancel and close the program.

Then open it again and make sure the System ID is the same as the first time.

Once the System ID is staying the same each time you open the program

you can contact us with your System ID to get a registration code that will

unlock the program.